In a previous post, we selected a site, cleared trees and installed foundations. Now we were ready for framing. There were four 8-inch concrete piers defining the four corners of the array. The plan was to mount two 10-foot 4-by-4 … Continue reading →
With the Solar Generator Project underway, it is time to mount the solar panel array. Last May, I purchased eight Renogy 270-watt solar panels similar to those in the Solar Rainwater Project. At 65 by 39-inches, and weighing 65 lbs., they require a substantial mounting system. In the Solar Rainwater System, I had the advantage of an existing building with a south-facing roof that could hold four panels.
Continue reading →
Two years ago, I installed a small solar system to pump water at the ranch. This solar generator makes us independent from the grid by insuring we can always pump water — even in a grid down event. I’ve learned a lot about solar power and want to continue. What about refrigeration? In a power failure we cannot refrigerate food or produce ice.
Continue reading →
For the last ten years, we’ve been farming bluebonnets (Lupinus texensis) around the place. It started when I planted a few seeds and gradually, they’ve bloomed and spread. Because I’m impatient, I also helped them along by mowing the plants after they had gone to seed and spreading the clippings to other parts of the ranch.
Continue reading →
A Massey Ferguson 65 is nice to have. Over the years, I’ve learned that a tractor is essential. The point was made in about 2002 when I decided to buy a truckload of decomposed granite to improve the driveway. After spreading 10 yards of material with a wheelbarrow and shovel, I realized there had to be a better way.
Continue reading →
Ikea makes a wonderful work light (JANSJÖ)that sells for about $13. I have several of them, and love the warm pool of light they provide on desk surfaces. Let’s convert one of them to solar power with the Altoids LED light project
Continue reading →
The Solar Powered Rainwater Project began about eight months ago, although one might argue it is the culmination of my rainwater system dreams beginning in 2002.
Continue reading →
The solar-powered rainwater system was complete — except for more panels, and a cable to isolate the rainwater power from the rest of the system. Construction on the rainwater system began in 2002, when I trenched the various wires and pipes into the ground. I needed power for the rainwater system, and tapped into an underground wire originally intended to supply power to the well.
Continue reading →
Every piano is different, and although there are recommended measurements for key dip, blow distance, hammer height, etc., changes are sometimes needed to suit a specific action. At this point, Danny Boone’s Regulating Grand Piano Touch and Tone suggested fully regulating … Continue reading →
With casters installed and a rudimentary understanding of action adjustments, I was able to tinker. Hammer alignment went quickly, and as predicted, the sotto voce pedal now worked properly. Since the rockers were not snugged into their final position, they tended to drift, so I touched up the hammer line and let-off, and put the action back into the piano. It was time to play!
Continue reading →