↓
 

Roy Creek Ranch

a Log Home in the Hill Country

Banner image of the Log Home on Roy Creek Ranch
  • Home
  • About
    • Amazon Associates Disclosure
    • Privacy Policy
  • Posts

Category Archives: Rainwater

Post navigation

← Older posts

How to Get a PumpSaver for a Water Well

Roy Creek Ranch Posted on May 26, 2021 by JimMay 26, 2021
photo of The PumpSaver as part of the Solar Rainwater System

With summer on the way, and an end to our rainy season approaching, I am reminded of the dry summer last year and concerns about the water table here at the ranch. Fortunately, our water well performed during the last year’s drought, but a number of our neighbors had trouble with their wells. Some troubles were resolved by a visit from the well-service company and a replacement part of two, but at least one well’s water level was low — resulting in low or no water output.

Continue reading →

Share this:

  • Click to share on X (Opens in new window) X
  • Click to share on Tumblr (Opens in new window) Tumblr
  • More
  • Click to share on Facebook (Opens in new window) Facebook
  • Click to share on LinkedIn (Opens in new window) LinkedIn
  • Click to share on Reddit (Opens in new window) Reddit
  • Click to share on Pocket (Opens in new window) Pocket
  • Click to share on Pinterest (Opens in new window) Pinterest
  • Click to email a link to a friend (Opens in new window) Email
  • Click to print (Opens in new window) Print
Posted in Rainwater, repairs, solar | Tagged DIY, equipment, how to, littelfuse, protection, pump, pumpsaver, rainwater, solar, well

Farming Bluebonnets is Easy

Roy Creek Ranch Posted on November 6, 2019 by JimDecember 2, 2019
photo of Our backyard filled with Bluebonnets

For the last ten years, we’ve been farming bluebonnets (Lupinus texensis) around the place. It started when I planted a few seeds and gradually, they’ve bloomed and spread. Because I’m impatient, I also helped them along by mowing the plants after they had gone to seed and spreading the clippings to other parts of the ranch.

Continue reading →

Share this:

  • Click to share on X (Opens in new window) X
  • Click to share on Tumblr (Opens in new window) Tumblr
  • More
  • Click to share on Facebook (Opens in new window) Facebook
  • Click to share on LinkedIn (Opens in new window) LinkedIn
  • Click to share on Reddit (Opens in new window) Reddit
  • Click to share on Pocket (Opens in new window) Pocket
  • Click to share on Pinterest (Opens in new window) Pinterest
  • Click to email a link to a friend (Opens in new window) Email
  • Click to print (Opens in new window) Print
Posted in Gardening, Greenhouse, machinery, Rainwater | Tagged back to the earth, Bearcat, bluebonnet, bluebonnets, chipper, equipment, farming, ferguson, harvest, hill country, how to, howto, Lupinus texensis, Massey, model 65, Mother Earth News, saving seeds, scythe, shredder, snathe, Texas, texas hill country, wildflowers

Solar Powered Rainwater Project – Completed?

Roy Creek Ranch Posted on November 15, 2017 by JimNovember 15, 2017
photo of Completed Solar Powered Rainwater System

The Solar Powered Rainwater Project began about eight months ago, although one might argue it is the culmination of my rainwater system dreams beginning in 2002.

Continue reading →

Share this:

  • Click to share on X (Opens in new window) X
  • Click to share on Tumblr (Opens in new window) Tumblr
  • More
  • Click to share on Facebook (Opens in new window) Facebook
  • Click to share on LinkedIn (Opens in new window) LinkedIn
  • Click to share on Reddit (Opens in new window) Reddit
  • Click to share on Pocket (Opens in new window) Pocket
  • Click to share on Pinterest (Opens in new window) Pinterest
  • Click to email a link to a friend (Opens in new window) Email
  • Click to print (Opens in new window) Print
Posted in Central Texas, Gardening, Greenhouse, maker, Projects, Rainwater, solar | Tagged amateur, ampere-hours, battery bank capacity, build, charge, controller, deep cycle, DIY, equipment, Grid-assist, grid-tie, ham radio, how to, howto, Interstate, inverter, kill-a-watt, kilowatt, kilowatt-hours, kWh, marine, mppt, off-grid, panel, panel wattage, pwm, rainwater, renogy, solar, solar panel wattage, storage, teardrop, trailer, wb0mmc

Solar Power Rainwater System – More Panels!

Roy Creek Ranch Posted on November 14, 2017 by JimNovember 15, 2017
photo of A solar-powered water shed

The solar-powered rainwater system was complete — except for more panels, and a cable to isolate the rainwater power from the rest of the system. Construction on the rainwater system began in 2002, when I trenched the various wires and pipes into the ground. I needed power for the rainwater system, and tapped into an underground wire originally intended to supply power to the well.

Continue reading →

Share this:

  • Click to share on X (Opens in new window) X
  • Click to share on Tumblr (Opens in new window) Tumblr
  • More
  • Click to share on Facebook (Opens in new window) Facebook
  • Click to share on LinkedIn (Opens in new window) LinkedIn
  • Click to share on Reddit (Opens in new window) Reddit
  • Click to share on Pocket (Opens in new window) Pocket
  • Click to share on Pinterest (Opens in new window) Pinterest
  • Click to email a link to a friend (Opens in new window) Email
  • Click to print (Opens in new window) Print
Posted in Greenhouse, maker, Projects, Rainwater, solar, Woodworking | Tagged amateur, ampere-hours, battery bank capacity, build, charge, controller, deep cycle, DIY, equipment, Grid-assist, grid-tie, ham radio, how to, howto, Interstate, inverter, kill-a-watt, kilowatt, kilowatt-hours, kWh, marine, mppt, off-grid, panel, panel wattage, pwm, rainwater, renogy, solar, solar panel wattage, storage, teardrop, trailer, wb0mmc

Solar Powered Rainwater Project – Final Assembly

Roy Creek Ranch Posted on July 15, 2017 by JimNovember 14, 2017
photo of the entire solar system

With all the parts in stock, it was time to assemble the whole Solar Powered Rainwater Project. I cleaned out a space in the garden shed, and added plywood to the wall for attaching the various components. We would be mounting the inverter/charge controller, solar panel combiner/breakers, A/C transfer switch and related wiring.

Continue reading →

Share this:

  • Click to share on X (Opens in new window) X
  • Click to share on Tumblr (Opens in new window) Tumblr
  • More
  • Click to share on Facebook (Opens in new window) Facebook
  • Click to share on LinkedIn (Opens in new window) LinkedIn
  • Click to share on Reddit (Opens in new window) Reddit
  • Click to share on Pocket (Opens in new window) Pocket
  • Click to share on Pinterest (Opens in new window) Pinterest
  • Click to email a link to a friend (Opens in new window) Email
  • Click to print (Opens in new window) Print
Posted in Central Texas, Greenhouse, maker, Projects, Rainwater, solar | Tagged amateur, ampere-hours, battery bank capacity, build, charge, controller, deep cycle, DIY, equipment, Grid-assist, grid-tie, ham radio, how to, howto, Interstate, inverter, kill-a-watt, kilowatt, kilowatt-hours, kWh, marine, mppt, off-grid, panel, panel wattage, pwm, rainwater, renogy, solar, solar panel wattage, storage, teardrop, trailer, wb0mmc

Solar Powered Rainwater Project – Batteries

Roy Creek Ranch Posted on July 11, 2017 by JimJuly 15, 2017
photo of Battery cart with batteries

You may recall from an earlier post that the Solar Powered Rainwater Project requires substantial battery storage. In our original calculations, we decided we would need 15,796 watt/hours of storage to provide three days of autonomy (or days without sun).

Continue reading →

Share this:

  • Click to share on X (Opens in new window) X
  • Click to share on Tumblr (Opens in new window) Tumblr
  • More
  • Click to share on Facebook (Opens in new window) Facebook
  • Click to share on LinkedIn (Opens in new window) LinkedIn
  • Click to share on Reddit (Opens in new window) Reddit
  • Click to share on Pocket (Opens in new window) Pocket
  • Click to share on Pinterest (Opens in new window) Pinterest
  • Click to email a link to a friend (Opens in new window) Email
  • Click to print (Opens in new window) Print
Posted in Central Texas, Greenhouse, maker, Projects, Rainwater, solar | Tagged amateur, ampere-hours, battery bank capacity, build, charge, controller, deep cycle, DIY, equipment, Grid-assist, grid-tie, ham radio, how to, howto, Interstate, inverter, kill-a-watt, kilowatt, kilowatt-hours, kWh, marine, mppt, off-grid, panel, panel wattage, pwm, rainwater, renogy, solar, solar panel wattage, storage, teardrop, trailer, wb0mmc

Solar Powered Rainwater Project – The Chinese Connection

Roy Creek Ranch Posted on June 26, 2017 by JimJuly 15, 2017
photo of The inverter box

It’s been a while since I reported on the Solar Powered Rainwater Project. Since that early-April post, I’ve been gathering the rest of the parts, and we took our annual trip to the Red Power Roundup — this year at the Iowa State Fair in Des Moines. The biggest part of the delay was waiting for the inverter/charge controller. I wasn’t thrilled with the delivery delay on the device, but it turned out well in the end.

Continue reading →

Share this:

  • Click to share on X (Opens in new window) X
  • Click to share on Tumblr (Opens in new window) Tumblr
  • More
  • Click to share on Facebook (Opens in new window) Facebook
  • Click to share on LinkedIn (Opens in new window) LinkedIn
  • Click to share on Reddit (Opens in new window) Reddit
  • Click to share on Pocket (Opens in new window) Pocket
  • Click to share on Pinterest (Opens in new window) Pinterest
  • Click to email a link to a friend (Opens in new window) Email
  • Click to print (Opens in new window) Print
Posted in Central Texas, maker, Projects, Rainwater, solar | Tagged battery, build, charge, China, Chinese, controller, deep cycle, DIY, hill country, homesteading, how to, howto, Interstate, inverter, panel, rainwater, renogy, solar, Sun Gold Power, Texas, texas hill country

Solar Powered Rainwater Project – Solar Panels Installed!

Roy Creek Ranch Posted on April 11, 2017 by JimMay 7, 2020
photo of The panel un-boxing

The new 250-watt solar panels arrived very quickly. I was eager to install them, but they were just a bit larger than I could handle safely on the garden shed roof. Fortunately, I didn’t have too wait long, and my neighbor Jason was available a few days later.

Continue reading →

Share this:

  • Click to share on X (Opens in new window) X
  • Click to share on Tumblr (Opens in new window) Tumblr
  • More
  • Click to share on Facebook (Opens in new window) Facebook
  • Click to share on LinkedIn (Opens in new window) LinkedIn
  • Click to share on Reddit (Opens in new window) Reddit
  • Click to share on Pocket (Opens in new window) Pocket
  • Click to share on Pinterest (Opens in new window) Pinterest
  • Click to email a link to a friend (Opens in new window) Email
  • Click to print (Opens in new window) Print
Posted in Gardening, maker, Projects, Rainwater, solar | Tagged build, charge, controller, deep cycle, DIY, hill country, homesteading, how to, howto, Interstate, inverter, panel, rainwater, renogy, solar, Texas, texas hill country

Solar Power Rainwater Project – Panels and Angles

Roy Creek Ranch Posted on March 23, 2017 by JimJuly 14, 2017
photo of the Spring Garden Shed

Major equipment purchase done, it’s time to think about the installation. The solar panels will be arriving in a day or two, and I plan to install them right away. Solar panels produce maximum power when the sun is perpendicular to … Continue reading →

Share this:

  • Click to share on X (Opens in new window) X
  • Click to share on Tumblr (Opens in new window) Tumblr
  • More
  • Click to share on Facebook (Opens in new window) Facebook
  • Click to share on LinkedIn (Opens in new window) LinkedIn
  • Click to share on Reddit (Opens in new window) Reddit
  • Click to share on Pocket (Opens in new window) Pocket
  • Click to share on Pinterest (Opens in new window) Pinterest
  • Click to email a link to a friend (Opens in new window) Email
  • Click to print (Opens in new window) Print
Posted in Central Texas, Gardening, maker, Projects, Rainwater, solar | Tagged amateur, build, charge, charge controller, compass, controller, deep cycle, DIY, equipment, framing square, Grid-assist, grid-tie, ham radio, how to, howto, inclinometer, Interstate, inverter, iphone, kill-a-watt, kilowatt, kilowatt-hours, kWh, marine, mppt, off-grid, panel, pwm, rainwater, renogy, solar, speed square, storage, teardrop, trailer, wb0mmc

Solar Powered Rainwater Project – to Grid-Tie, or not to Grid-Tie. (that is the question)

Roy Creek Ranch Posted on March 22, 2017 by JimJuly 14, 2017

Previously, we discussed the amount of power needed, and how that determines the size of the solar array. We also mentioned Days of Autonomy and how that informs battery storage. Now for Charge Controllers and Inverters — the brains that tie everything together. … Continue reading →

Share this:

  • Click to share on X (Opens in new window) X
  • Click to share on Tumblr (Opens in new window) Tumblr
  • More
  • Click to share on Facebook (Opens in new window) Facebook
  • Click to share on LinkedIn (Opens in new window) LinkedIn
  • Click to share on Reddit (Opens in new window) Reddit
  • Click to share on Pocket (Opens in new window) Pocket
  • Click to share on Pinterest (Opens in new window) Pinterest
  • Click to email a link to a friend (Opens in new window) Email
  • Click to print (Opens in new window) Print
Posted in Central Texas, Gardening, maker, Projects, Rainwater, solar | Tagged amateur, build, charge, controller, deep cycle, DIY, equipment, Grid-assist, grid-tie, ham radio, how to, howto, Interstate, inverter, kill-a-watt, kilowatt, kilowatt-hours, kWh, marine, maximum power point transfer, mppt, off-grid, panel, pulse width modulation, pwm, rainwater, renogy, solar, storage, Sun Gold Power, teardrop, trailer, wb0mmc

Post navigation

← Older posts
©2025 - Roy Creek Ranch - Weaver Xtreme Theme Privacy Policy
↑